I want to share with you a way to make minimalist bracelets on a ready base without pins.
I decided to make a simple bracelet using a base for bracelets and ran into a little difficulty. When I assembled the bracelet, an additional ring on a pin appeared, which spoiled the look.
After thinking about how to hide these rings I decided not to use a pin :)

There is not enough material for a DIY, but I will share with you this method anyway, maybe it will help someone.
We have a bead and a base for a bracelet. We will connect them using rubber bands for bracelets.

Thread a rubber band through the bead and the connecting ring of the bracelet.

Go back through the bead and the other end of the bracelet.

Tie 3-4 nodes. The tension of the band must be not very weak and not very strong. In the first case it will appear, in the second there will be big chances that you will tear it. Additional length of the band for a bead with a size of 1-2 cm should be 3-6 mm.

Cut the excess band, but not too much, about 2-3 mm will be enough and the band won't untie.

Stretch the rubber band.

Using a thin tool pull the knot closer to the bead.

With the weakening of the tension the knot will hide in the bead along with the "tails".

I wish you successful experiments!